Ask C100 Bedienungsanleitung PDF herunterladen (Seite 2)

Extron • System 8/10 P

LUS

• User’s Manual • P/N 68-548-01 Rev. B

ASK Installation Configuration and Connections

Page 2

ASK A10+ Projector Configuration

Verify that the System 8/10 PLUS is already configured for the ASK A10+

projector. The general setup is explained on page 3-4 and the switch settings for

the projector are repeated below.

1. Use a small screwdriver to remove the access cover from the System 8/10 PLUS

front panel. See bottom of page 3-3. The label on the back of the access cover

also has the configuration information.

__________ Before changing anything, remove the AC power cord to the System 8/10 P

LUS

to verify that the main power is OFF; also turn the projector power OFF.

2. Set the switches as follows:

Config Model Rotary Switches Cable SW15 Settings Comm

as RS1 RS2 RS3 RS4 J2/J3 1 2 3 4 5 6 7 8 9 10 Adapter

✔ ASK A10+ 0 0 E 9 J2 ↓↓ ↑ ↓ ↑↓ ↑ ↓

↑↓ 26-467-01

_RS5 is for RGB switching

delay. See page 3-4 for

more information on switch

functions.

3. Use a grease pencil (or other rub-off marker) to mark the space on the label next

to “ASK A10+”.

4. Locate the switcher’s Address DIP switches on the rear panel, lower right. Unless

this is part of a master/slave system, set #3 and #5 to the up position and the

others down. See illustration to the left.

Use the illustration on the following page to do the next steps.

5. Connect the ASK adapter’s 26-pin male connector to the projector’s “Source 1“

port. Next, connect the Comm Adapter’s 9-pin female connector to the projector’s

“RS-232” port.

6. Connect the CC-50' (or CC-100') cable from the 9-pin male connector of the Comm

Adapter to the 15-pin HD “Projector Control” port located on the rear panel of the

System 8/10 PLUS.

______ Secure the screws on all D connectors.

7. Connect the BNC (RGBS) cables from the System 8/10 PLUS outputs to the ASK

adapter’s 15-pin male “Computer” connector. For composite video, connect the

RCA connector from the System 8/10 Plus to the composite video “C” connector

of the ASK adapter. For S-video, connect the DIN connector from the System 8/

10 Plus to the S-video “S” connector of the ASK adapter.

Configured For:

RS-232

345678 9101

SW15 DIP Switch

RS5 RS2

RS2

RS1

RS3

RS4

RS1

RS3 RS4

1 2 3 4 5 6 7

Kommentare zu diesen Handbüchern

Keine Kommentare

Ask C100 Bedienungsanleitung Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Projektoren Ask C100